Filter Results By:
Products
Applications
Manufacturers
- Applied Instruments, Inc.
product
RF Noise Source
NS-3
The NS-3 Broadband RF Noise Generator provides an extremely flat AWGN (Additive White Gaussian Noise) signal from 5 to 2150 MHz. The output level adjusts in 0.1 dB steps over a 30 dB range.The bench-top configuration is standard and an optional two unit rack enclosure is available. The RS232 or USB remote control interface simplifies its use in automated test and factory ATE environments. The NS-3's combination of range, versatility and value make it the ideal general purpose broad-spectrum signal source for bench and ATE applications, including C/N, BER, MER, PER testing and rain fade simulation.
-
product
Rain Test Chambers
Shanghai Morningtest Environmental Chambers Co.,Ltd.
Rain test chambers for ingress protection testing simulates rain/water test as per IEC 60529 and DIN 40050-9((IP Code standard)) test standard. • IPX1 Protection against vertically dripping water• IPX2 Dripping water ± 15° from vertical• IPX3 Protection against spraying water• IPX4 Protection against splashing water• IPX5 Protection against low pressure jetting water• IPX6 Protection against high pressure jetting water• IPX7 Protection against temporary immersion• IPX8 Protection against continuous immersion• IPX9K Extremely high pressure jetting water
-
product
Standard Electromagnetic Vibrator
KD-9363-EM
King Design Industrial Co., Ltd.
The purpose of vibration testing is to make a series of controllable vibration simulation in lab, no matter generated by natural or man-made vibration environment; such as waves, tidal flaps, wind, earthquake or rain and so on. It is to test if the product is capable of sustaining the vibration environment exerted from transporting or usage along its effective life cycle; and certify the standard of design & functional requirement of product. The value of vibration testing is to confirm the reliability of products and effectively screen out the bad products in factory; avoiding damages occurred at arrival; and to assess the failure analysis on the non-performing products; expecting to reach a high standard, high-reliability products. The vibration test stresses on the continuity and fatigue; and contributes to the understanding of product’s status under vibration circumstance in a normal environment; and avoids the product’s unpredictable damage caused under certain vibrating frequency for a long time.
-
product
Bundesmann Water Repellency Tester
M230
The Bundesmann provides a water repellency test for fabrics that are being contacted during use such as a rain jacket. Samples are mounted over a cup and are rubbed from underneath during the test.
-
product
Tipping Bucket Rain Gauge
HD2013
The HD2013 is a reliable and sturdy tipping bucket rain gauge, built entirely from corrosion resistant materials in order to guarantee reliability, accuracy and durability.and to withstand even extreme conditions. Depending on the environment where the rain gauge is placed, there is a choice between heated or non-heated version (HD2013R).
-
product
Freezing Rain and Ice Detectors
Freezing-rain and ice detectors detect the presence of icing conditions so that appropriate actions can be taken to prevent damage to power and communication lines, to warn of road hazards, to keep ice off a plane’s wings, and to prevent ice from forming on turbine blades.
-
product
Tipping Bucket Rain Gauge
HD2015
The HD2015 is a reliable and sturdy bucket rain gauge, entirely constructed of corrosion resistant materials in order to guarantee its durability.
-
product
IP code Testing
Educated Design & Development, Inc.
Complies with various IEC, EN, CE, VDE, UL & CSA requirementsUnit comes with NIST traceable / ISO 17025 accredited certificate of calibration.ED&D is ISO 17025 accredited by ACLASS, an ILAC Member. Measurement data and uncertainty data is available.Uses RTS-01 Rain Spray Head
-
product
Water-cooled Light & Weather Fastness Tester
TF422
TESTEX Testing Equipment Systems Ltd.
Water-cooled Light & Weather Fastness Tester, to determine the color fastness, aging resistance of textiles, plastics, rubber products or materials by objecting to the simulated conditions of nature weather (daylight, rain, temperature and humidity, etc.). The tester simulates both light and dark cycles and nature weather conditions by rack sprays and water-cooled long-arc-xenon lamp equipped.
-
product
Present Weather Sensors
Present weather sensors use a laser-based technology to measure the size and velocity of water droplets in the air to determine visibility, measure precipitation rate, and identify precipitation type (for example, drizzle, rain, snow, and hail). These sensors are often incorporated in automatic weather stations for road, marine, and airport applications.
-
product
IPX56 Simulation Rain Test Chamber
CX-IPX56A
Shenzhen Chuangxin Instruments Co., Ltd.
IPX56 Simulation Rain Test Chamber widely used in the lamps and electrical and electronic product certification testing institutions and for testing the waterproof of electrical and electronic products of shell protection level.
-
product
IPX5 IPX6 Water Spray Test Device
CX-IPX56B
Shenzhen Chuangxin Instruments Co., Ltd.
Drop rain rain chamber Uses: This equipment is main to test the physical and other related properties of the products in the environment of simulated rain, such as electronic and electrical products, lamps, electrical cabinets, electrical components, automobiles, motorcycles and their parts and components. After the test, through the test result to determine
-
product
Present Weather Sensors
Bristol Industrial & Research Associates Ltd
Biral forward scatter Present Weather Sensors measure visibility and report precipitation type and intensity. These compact sensors can identify a wide range of precipitation types including drizzle, rain, snow, hail, freezing rain and other forms of frozen precipitation. Precipitation type is reported using a combination of WMO Table 4680 and METAR codes. The range of precipitation types identified varies with sensor model.
-
product
IPX3/4 Swing Pipe Rain/ Water Spray Chamber
Shenzhen Chuangxin Instruments Co., Ltd.
Ipx3/4 Swing Pipe Rain/ Water Spray Chamber 1. Item name: Ipx3/4 Swing Pipe Rain/ Water Spray Climatic Chamber
-
product
IPX12A Rain Test Chamber
CX-IPX12C
Shenzhen Chuangxin Instruments Co., Ltd.
CX-IPX12A rain test chamber is in accordance with IEC 60529: 2001 "Degrees of protection provided by enclosures (IP Code)".
-
product
Power Quality Analyzer
APQM-700
*4 current inputs, physical current measurement on the neutral conductor.*Recording of up to 1100 parameters, including average, maximum, minimum and instantaneous values*Built-in heater, stable operation at low temperatures down to -20ºC.*Internal rechargeable battery, meter autonomy (min. 6 hours)*Ingress protection IP65, possibility of working in rain, snow and high humidity.
-
product
Box Rain Test Chamber
Comprehensive box rain test chamber (with swing pipe and right angle tube) is used to test the electric and electronic devices by simulating natural rainfall with spraying water from the water nozzles (holes) on swing pipe or straight tube. To estimate and recognize if the shell or sealing elements of these device could ensure a good condition of working during and after the test. The products are widely used in the industries of light, electrical, electronics, automobile, motorcycle, household electric appliances, electromechanical equipment, instruments and meters, and other industries.
-
product
Data Logger with GSM/GPRS Module
HD33M-MB.2
GSM/GPRS data logger. RS485 MODBUS-RTU input, additional contact input for rain gauge. Great to combine with HD52.3D and HD51.3D series anemometers!
-
product
Miniature Zirconia Oxygen Analyzer with Pump to be DIN Rain Mounted as a True OEM
Rapidox 1100Z-OEM-RSB & 1100ZR3-OEM-RSB
The new Rapidox 1100Z-OEM-RSB is the World’s first miniature zirconia oxygen analyser with pump designed to be DIN rail mounted into customer’s equipment as a true OEM. The Rapidox 1100-OEM-RSB is a cost-effective 24Vdc OEM version of our sampling 1100 zirconia analyser range. The package has been shrunk down and simplified to fit onto a DIN rail in an electrical cabinet, and comprises a compact control unit (with or without OLED display and menu keypad), a zirconia sensor with sample connection points, a particle filter and a powerful miniature sample pump capable of drawing a gas sample at up to 1.5 litres per minute through 6mm OD/4mm ID flexible tubing.
-
product
IPX3/4 Waterproof Testing Machine
IPX1000R
Shenzhen Chuangxin Instruments Co., Ltd.
The IPX3/4 Waterproof Testing Machine is designed according to the <> of IEC60529 standard, GB7000.1 and GB4208-2008. IPX3/4 Waterproof Testing Machineis mainly used to simulate the product under the condition of the rain climate to test the products’ physical properties.
-
product
Bundesmann Rain Tester
Sataton Instruments Technology CO., Ltd
Bundesmann rain tester which is also called as Bundesmann water repellency tester can provide artificial rainfall to simulate the process of rain under natural environment. The tester is designed to determine the water repellency of fabrics by the bundesmann rain shower method. It can provide water repellency performance of tested materials under a certain rainfall in a certain time.
-
product
Precipitation Detector
HD2013.2
The HD2013.2 is our rain detector based on the capacity principle. The capacity value of the sensitive element, on an alumina rest, changes according to the surface dampened by raindrops. An integrated heater keeps it dry, evaporates water and prevents false signals caused by fog or dew.
-
product
IEC60529 IPX3-IPX4 Rain Proof Test Machine
CX-IPX34A
Shenzhen Chuangxin Instruments Co., Ltd.
IEC60529 IPX3-IPX4 Rain Proof Test Machine Application The rain test system is strictly designed according to IEC60529. It’s applied to the Electrical equipment of the waterproof test of IPX3 and IPX4.
-
-
product
RFID
Zebra Technologies Corporation
Leverage Zebra’s decades of expertise, design thinking and software development to achieve maximum RAIN RFID efficiency, while minimizing the pains of multi-vendor solutions. Unlike other players, Zebra gives you the industry’s broadest, field-proven RFID portfolio for unmatched accuracy and interoperability. Connect it all and create a platform that elevates every system, device, tag and worker.
-
product
Rainfall Transmitter
Model A70 Rainfall Transmitter converts the signal from a tipping bucket rain gauge into a 4-20 mA signal for input to a computer, meters, system controls or other instrumentation. It features reliability, low cost, accuracy, simplicity of operation and ruggedness.
-
product
IEC60529 IPX1 To IPX4 In One Waterproof Rain Test Chamber
CX-IPX14
Shenzhen Chuangxin Instruments Co., Ltd.
IPX1 to IPX4 in one waterproof rain test chamber/equipment
-
product
Water Testing Kits
Omega's Water Testing Kits monitor water quality in any commerical, residential, or industrial application. Rain and snow gauges are available for accurate measurement for Meteroligists
-
product
Rain Test Chamber
Wewon Environmental Chambers Co, Ltd.
Water pump for rain test chambers uses highly pressure stainless steel pump, ensure water pressure and flow of the test cycle, the pump is installed in the side of the IP test device, and both ends of the inlet and outlet to set up the joint, easy to replace and repair. Water tank can be disassembled,The corresponding joint or hose connection is arranged in the water pipe connection.
-
product
Water-cooled Light & Weather Fastness Tester
TESTEX Testing Equipment Systems Ltd.
Xenon Lamp Weather Resistance Test Chamber, to determine the color fastness, aging resistance of textiles, plastics, rubber products or materials by objecting to the simulated conditions of nature weather (daylight, rain, temperature and humidity, etc.). Water-cooled Light Fastness Tester complies with ISO105 – B02 / B04 / 06, AATCC 16, AATCC 169, etc.
-
product
IP X5, X6 - Walk-In Rain Test Chamber
WEIBER designs and manufactures standard as well as customized water spray test chamber for evaluating various automotive, electrical and electronics items under water, rain or shower conditions. The chamber interrogates the performance of parts when subjected to water droplets.The system is based on the IP X5, X6 specification requirements, and can also accomplish individual automaker’s tests, as well as electrical-enclosure tests.Our system uses multiple control solenoids to vary the water's spray volume/pressure. A holding tank prepares the water to the desired temperature, if required. A pump ensures the water is delivered in the proper pressure range.
