Filter Results By:
Products
Applications
Manufacturers
Perpendicular Magnetic Recording
1) professional mobile radio with a range of fifty kilometers. 2) vertical to spinning disk data bit magnetization.
-
product
Magnetic Measurement
DiskMapper H7 System
The DiskMapper H7 system quickly determines the uniformity of the perpendicular recording layer of Heat Assisted Magnetic Recording (HAMR), also called Thermally Assisted Recording (TAR) disks, immediately after deposition, an important factor in the yield of disk drives. Utilizing a custom 7 Tesla bi-polar high speed superconducting magnet, the hysteresis loop of any disk location can be measured in less than 3 minutes.
-
product
Audio Mastering Magnetic Recording Heads
International Electro-Magnetics, Inc.
*Tape and Film*Standard Replacement*Instrumentation Quality*Custom Formats
-
product
Erase Magnetic Recording Heads
International Electro-Magnetics, Inc.
*Dual Gap Ferrite Cores*Cassette - 2" Formats*MultiTrack Interlace*Full Track 1" Video
-
-
product
Data Recording System
Director DII - DFR DDR
Using the Microsoft Windows 10® operating system, DII features complete Transient and Long-Term Phasor Data Recording, Analysis, and Transmission. E-MAX DII has a maximum capacity of 128 Analog and 256 Digital directly connected channels.
-
product
Magnetic Resonance
Magnetic resonance is a unique non-invasive and non-destructive research tool that aids in the study of living cells and tissues as well as provides detailed analysis of molecular solutions and body fluids.
-
product
Magnetic Encoders
The absolute linear BML magnetic encoders from Balluff provide for absolute position feedback in any position – ready to use and without a reference run. Even after loss of power supply and restarting the system.
-
product
Magnetic Plugs
Magnetic Drain Plugs were pioneered by Lisle Corporation in the 1930's. Lisle MAGNETIC PLUGS are similar to standard pipe or straight thread drain plugs with one important difference – a permanent magnet is fastened to the plug body. This magnet attracts and holds abrasive, ferrous metal particles preventing their circulation through the lubrication or hydraulic system.
-
product
Data Recording
The documenting of data and observations in a variety of forms in order to preserve it for later use.
-
product
Current Sense Magnetics
Current sense magnetics are used as a low loss method for sensing AC current in a circuit and also provide electrical and safety isolation between the source of the current and the measurement circuit. The key parameters for a current sense transformer are the rms current rating (to ensure it does not overheat in the application) and the safety and voltage isolation (to ensure it conforms to the end-application requirements).
-
product
Fault Recording Monitors
Comprehensive, flexible, scalable and compatible – full multi-function devices.
-
product
Magnetic Profile Measurement
Many times it is requires to study the magnetic field profile of the 2D or 3D surface to estimate the performance of the magnetic device. The field pattern is measured by sensors and very precise mechanical arrangement. The spacing between two points of measurement can be as low as a few microns. This precise measurements can confirm the quality of performance of any device.
-
product
Magnetic Stripe Analysers
Companies who aim to deliver the highest quality magnetic media products to their clients choose Barnes Magnetic Stripe Analysers. They are used by magnetic stripe card producers, card and ticket manufacturers and bureaus for ISO and CQM testing, production quality control, encoding equipment maintenance and development.
-
product
Perpendicular MRAM
Polar Kerr System
The Polar Kerr System for MRAM utilizes the polar Magneto-Optical Kerr Effect (MOKE) to characterize the magnetic properties of multi-layer wafers used in the development and manufacturing of perpendicular MRAM. Utilizing a non-contact full-wafer measurement technique, the system creates a map of the magnetic properties of entire wafers up to 300 mm. The system is available in a manual loading or fully-automated configuration for use in R&D and/or production.
-
product
Solution for Flight-Data Recording and Analysis
dataMARS104
AMPOL's reliable and field-proven product, the dataMARS104, is a complete, state-of-the-art, flight qualified solution for recording, monitoring and analyzing flight data. Once the unit is installed on the aircraft, its solid-state recording media can be easily removed and taken directly into the lab for analysis and report generation. Its included unique and powerful post-analysis software has the ability to decode flight data on-the-fly, even while recording is in progress providing an accurate, up-to-date, realtime picture of the data as it happens.
-
product
Magnetic Field Visualization
magview
The magview is a mobile hand-held device equipped with a magneto-optical (MO) sensor for the rapid visualization of magnetic structures and stray fields with the eye.
-
product
Magnetic Field Generator
PFM61000-8A
PFM61000-8A Magnetic Field Generator is high reliability test equipment with stable performance, specially designed for electrical and electronic products for measuring immunity characteristics and requirements of normal frequency magnetic fields. It provides an accurate basis for the tested equipment in the immunity test of normal frequency magnetic field. The generator can imitate the magnetic field environments such as residential, commercial, industrial and mining enterprises, power plants, as well as middle and high substation. It fully meets IEC61000-4-8 and GB / T17626.8 standards.
-
product
Magnetic Powder Testing
It is very important to measure the content of magnetic allow in toner powder. The accuracy with which the measurements are carried out determines the quality of the powder. Fluxmeter with a specially made coil can give accurate results of the percentage quantity of the magnetic material in the toner powder.
-
product
Magnetic Thermometers
113
The magnetic thermometers are based on a bimetallic strip and therefore do not require batteries but do require time to adjust to the temperature.
-
product
Magnetic Level Gauge Switches
ABB's magnetic level gauge switches for point level alarm and/or control can mount to a KM26 magnetic level gauge or an LS Series cage level switch.These switches are completely isolated from the process fluid as they are magnetically activated by a magnet equipped float (KM26) or attraction sleeve (LS Series). The unique magnetic coupling action eliminates seals, diaphragms, springs, and torque tubes common to other level switching alternatives since there is no physical contact with the process fluid. The magnetic coupling also eliminates process connections to the switch; therefore, no isolation valves are required to block off the switch for maintenance. The switch "set point" is easily adjustable without changing any process piping and the result is a more reliable and easier way to maintain level system.
-
product
Magnetic Speed Sensors
We offer the most comprehensive portfolio of magnetic speed sensors ICs, covering the full range of speed and speed with direction, two- and three-wire interface, magnetic encoder (ring magnet) and gear tooth sensing, Hall and GMR technology, and ASIL-compliant options for transmission, wheel speed, engine, e-motors, and many more encoder and gear tooth sensing applications.
-
product
Magnetic Measurement System
Model 110
The Model 110 Magnetic Measurement System is a very high field version of our industry-standard MESA, designed specifically to measure high-coercivity samples. It uses powerful amplifiers and specially designed water-cooled solenoid assemblies to achieve the magnetic fields required by state-of-the-art material.
-
product
Nuclear Magnetic Resonance Equipment
SpecFIT HR50
Low-field Nuclear Magnetic Resonance (TD-NMR) equipment with easy-to-use software and certified analysis (ISO, AOCS, etc.).
-
product
Magnetic Locators
ML Series
The ML series offers simple one-handed operation with an easy-to-learn keypad featuring only three buttons - no menus or cumbersome instructions to follow. The audio unit has the volume built into the on/off key; just hold down the key while it cycles through the settings. The ML-1 features strong monotube construction, providing structural integrity you can count on.
-
product
Magnetic Field Sensors
SpinTJ
The SpinTJ magnetic sensor family builds upon Micro Magnetics? in-house expertise developing low-field magnetic tunnel junction sensor products. Based on our proprietary fabrication processes, we have developed patented recipes for fabricating macroscopic, micron-scale, and submicron MTJ field sensors.
-
product
Magnetic Field Meter
Measurement for the magnetic field generated from Direct Current (DC, with display by N/S Magnetic polarity) or Alternating Current (AC in 40-500Hz).
-
product
Miniature Airborne Recording System
MARC II
The MARC II is a complete Miniature Airborne ReCording system designed to record messages of several communication protocols. Small, light, with low power consumption and large storage capacity for recorded data, the MARC II is the perfect standalone solution for airborne recording.Ethernet is built-in to the MARC II. In addition to Ethernet, you can order the MARC II with up to three additional modules of the supported protocols.
-
-
product
Magnetic Field And Permeability Measurement
MAGNETOMAT 1.790
Foerster Instruments, Incorporated
The MAGNETOMAT 1.790 is a measuring system for the precision detection of magnetic flux density and relative permeability. The MAGNETOMAT software is used for displaying the measured values and saving and exporting data. The wide range of probes facilitates optimal adjustment to the conditions of the application, such as the measurement of relative permeability within the scope of the quality control of stainless steel and low-permeable (non-magnetic) alloys. Further applications include the long-term monitoring of the magnetic environment, e.g. prior to installing magnetically sensitive devices, and the localization of ferrite enclosures in stainless steel and NE materials. Changes in material (sulfidation, degradation of lamination, structural changes) can also be proven thanks to permeability comparative measurements.
-
product
Magnetic & Current Sensors
From the International Space Station to a simple electronic compass, we can provide a solution to meet your magnetic semiconductor needs. The F.W. Bell® product line was founded in 1944. Since then we have been a pioneer in developing instrumentation to measure electric current and magnetic fields.
