Filter Results By:
Products
Applications
Manufacturers
Antennas
any structure or device used to collect or radiate electromagnetic waves.
See Also: Broadband Antennas, Log Periodic Antennas, Directional Antennas, HF Antennas, Biconical Antennas, Horn Antennas, Isotropic Antennas, Loop Antennas, Antenna Software, Antenna Analyzers, Dipole Antennas, Transmitters, MIMO
- Pickering Interfaces Inc.
product
RF & Microwave PXI Switch Modules
These switching systems are used for design validation, reliability and production test including 5G, SD radios, S parameter testing for RF cables, antennas, radar and semiconductor verification.
-
product
Manpack MW Antenna
TGR-50 class
The TGR-50 class of rapidly deployable AM antennas is designed for easy transport and erection by limited personnel. No tower climbing or sophisticated lifting equipment are required for installation by a crew of three or four persons. Weight and packaging, according to model, typically permits transport by bearers, light vehicle, small boat, or helicopter. Disassembly and relocation is similarly convenient.
-
product
Horn/Notch Antennas
Horn and Notch Antennas perform well over wide bandwidths while providing directive radiation patterns and moderate gain levels. CAES offers an extensive range of products including conical, pyramidal and sectoral horn antennas, as well as dual-polarized, high-power tapered notch antennas.
-
product
LMR/TETRA/P25 Antennas
These reliable and secure LMR and TETRA antenna solutions support mission critical communications.
-
product
Antenna Tuner
DU-3000T/DU-3000TB
The DU 3000T and DU3000TB tuners optimize the performance of your antenna and transmitter or SWL receiver by providing adjustable impedance matching. The DU-3000 series also measure the Power and Standing Wave Ratio (SWR), which allows you to tune the indicated SWR to the lowest possible value for the selected transmitfrequency.
-
product
Bi-Sector Array Antennas
*Dual 33 degree beam antennas with a 65 degree pattern foot print*Multi-band capable*IIndependent tilt control for each beam**RemoteElectricalTilt (AISG 2.0)*Increase site capacity & data throughput
-
product
Spare Parts
Gigahertz Solutions Spare Parts - antennas, protective cases, grounding cables and wires, tension sets, connection cable analyzers, and more
-
product
Antenna, Log Periodic
EM-6954 | 70 MHz – 1 GHz
The EM-6954 is designed to meet antenna requirements for both field strength measurement and radiated susceptibility in the 70 MHz to 1 GHz frequency range.
-
product
EMC Accessories
Complete your EMC test setup with the essential accessories to compliment the test equipment. Whether it is a LISN (or V-Network) to counteract interference from external power sources on conducted emissions from the device under test, probes to locate the near field sources of radiated emissions, receive and transmit antennas, or tripods for holding antennas in place, the Rohde & Schwarz catalog of EMC accessories provides the additional items you need for EMI and EMS measurements, guaranteed 100% suitable for use with Rohde & Schwarz EMC test equipment.
-
product
GPS Wireless Clock
Signals & Systems India Private Limited
GPS Clock offers an easy, cost-effective solution for accurate, synchronized time displays without expensive, disruptive installation procedures. Because there are no wiring requirements, installation times are drastically reduced. It is ideal for renovation projects, as there is no need to worry about installation work, as well as new construction. The GPS clock can be synchronized through GPS Antenna or Wireless Antenna. The display can be wall/panel / tabletop mountable. It can be used as a wireless clock to synchronize many wireless slave clocks in and around the buildings.
-
-
product
4-20mA Output Inclinometer
LCF-2330
The LCF-2330 inclinometer series now includes a 4-20mA output signal option for applications that require long cable runs. This dual axis tilt sensor is fluid damped to minimize noise and vibration interference while also offering a sharp 1 µradian resolution. An internal temperature sensor is available and dual supply, ± 5 Vdc output is an option. The LCF-2330 is an excellent solution for rugged applications such as radar & antenna leveling, weapons platform leveling, barge and offshore platform control, deviation surveys, 2-axis machine tool leveling, bridge structural monitoring, submersible control feedback, offshore platform stability and manufacturing process equipment for the aerospace industry.
-
product
Outdoor Antennas
Our portfolio of outdoor antennas includes products for numerous wireless applications, including cellular, Bluetooth, Wi-Fi, ISM, and GNSS. They are available in a wide range of types and formats, with multiple connector options. Their rugged design and IP ratings indicates they are suitable for use in outdoor applications and in harsh environments. Custom antenna developments are regularly undertaken to meet specific customer requirements. Our outdoor antenna portfolio includes antennas manufactured by TE Connectivity, Laird Connectivity External Antennas, and Hirschmann Car Communications.
-
product
5G 256-Element Active Antenna Innovator’s Kit
AWA-0134
The AWA-0134 is an active array for 5G wireless applications developed using planar antenna technology resulting in a very low profile, lightweight unit. The surface mount assembled antenna board is based on Anokiwave’s AWMF-0108 Silicon Quad Core IC and demonstrates the performance achievable using low power silicon integration and efficient antenna layout and design. Using the AWMF-0108, the antenna provides +60dBmi (1000 W) of EIRP. The electronic 2D beam steering is achieved using analog RF beam forming, with independent phase and gain control in both Tx and Rx operating modes. The AWA-0134 antenna leads the way in showing how 5G coverage can be rolled out by network operators using the mmW bands, with low power footprint and high energy efficiency, while meeting key operating specifications for data rate, latency, coverage, and reliability.
-
product
Antenna
Our expertise in 3-D EM computation accelerates the antenna development through accurate simulations and performance optimizations with full CAD description of devices and precise definitions of materials.
-
product
Direction Finder Components
Doppler Systems offers direction finder components that can be paired with your narrow band FM receivers to create an accurate, low-cost radio direction finder (RDF). Our direction finder components include processors and fixed site and mobile antennas.
-
product
L-Band RF Tuner and 2-Channel 200 MHz A/D with Virtex-6 FPGA - 6U VPX
Model 57690
- One L-Band tuners accept RF signals from 925 MHz to 2175 MHz- One programmable LNAs boost LNB (low-noise block) antenna signal levels with up to 60 dB gain- One programmable analog downconverters provide I + Q baseband signals with bandwidths ranging from 4 to 40 MHz- Two 200 MHz 16-bit A/Ds- Supports Xilinx Virtex-6 LXT and SXT FPGAs- Up to 2 GB of DDR3 SDRAM; or: 32 MB of QDRII+ SRAM- PCI Express (Gen. 1 & 2) interface up to x8- Clock/sync bus for multiboard synchronization- Optional user-configurable gigabit serial interface- Optional LVDS connections to the Virtex-6 FPGA for custom I/O- Ruggedized and conduction-cooled versions available- Synchronize up to eight modules with Model 7893 System Synchronization and Distribution Amplifier - PCIe
-
product
Spot-Focusing Lens Antennas
The antenna employs a low loss lens to offer excellent aperture efficiency at 105.96 GHz. The lens antenna is equipped with a standard WR-10 waveguide and UG-387/U-M flange as its input port. It supports linear polarized waveforms.
-
product
Cable & Antenna Analyzers
Site engineers and technicians have been using sweep testers also known as cable and antenna analyzers to validate installations or to find trouble locations and imperfections in wireless sites.
-
product
Standard Gain Horn Antennas
Linear polarized Broadband Horn Antenna (Brass with Plastic mounting body) for Receive and Transmit Applications.
-
product
Vehicular Antennas
Pulse manufactures a diverse line of outdoor automotive antennas. Our ruggedized, built- to-last antennas cover frequencies 136 MHz to 6 GHz, including GNSS and multi-band antennas. Most antennas are available in a variety of mounting styles including NMO, direct mount, glass, and magnetic mounts, and in many different form factors such as low profile, stealth blade, low profile transit, and whips. Pair your vehicular antenna with our wide variety of high performance, high frequency NMO Mounts making your vehicular installation easier while also insuring the best possible antenna performance. Pulse is a leader in automotive aftermarket antennas and has been a main supplier to large Automotive OEM’s for decades. Find your next automotive antenna and NMO Mount today using the product finder below.
-
product
Fluid Rotary Joints
EVERAXIS Fluid Rotary Joints are designed to operate at extreme pressure and with high flow. The main application is the cooling of radar antennas. Fluid Rotary Joints are commonly integrated into rotary joint systems together with RF rotary joints, FORJ and slip rings.
-
product
Compact Anechoic Chambers
If you have mmmwave or THz antenna phased-array that require Over the Air measurements, MilliBox has the equipment and tools that you need. With the help of MilliBox compact anechoic chamber system, you can plot radiation pattern , collect data from those plots, and assess your antenna performance easily and precisely.
-
product
Dual-ridge Horn Antenna 1 to 18 GHz
EH118
EH118, a dual-ridge horn antenna that will operate from 1 to 18 GHz. This antenna has a balanced, smooth antenna factor curve that extends all the way to 18 GHz, a reduction of higher order modes on the aperture, and low return loss (SVSWR). The EH118 is applicable for commercial, military and automotive test standards and will include applicable calibrations. The EMC dual-ridge horn antenna offers these key features: single linear polarization, smooth/balanced gain with frequency, low return loss /VSWR, and ultrawide bandwidth (18:1).
-
product
Array Solutions OCF
Series Dipoles
Thank you and congratulations on your purchase of the Array Solutions, OffCenter Fed HF Dipole Antenna System. This antenna was built with the same quality workmanship and attention to detail as our military, government and commercial wire antenna products. It is ideal for ARES/RACES, MARS/CAP, USCG Aux., Red Cross, Salvation Army and other disaster and relief organization use. It is built especially for high duty cycle, harsh environmental applications. The use of the finest quality components available and our “overbuilt” quality construction means your new antenna will last for years under the most difficult conditions, while requiring little or no maintenance.
-
product
Time-domain Field-Device-Circuit coupled simulator
EM-SUPREME®
Time-domain Field-Device-Circuit coupled simulator for modeling of passive structures, active components, and complete RF & millimeter-wave modules. EM-Supreme is used for EM modeling of power amplifiers, switches, filters, active antennas, and complete RF modules such as antenna-switch, switch-filter, switch-filter-amplifier, and front-end modules with no approximations.
-
product
PDS Motion Scan
Allows a 3D Scanning sonar user to collect motion compensated 3D point clouds from a moving platformTeledyne PDS MotionScan system allows a 3D Scanning sonar user to collect motion compensated 3D point clouds from a moving platform. The MotionScan system is comprised of: an RTK capable dual antenna GPS with precision heading output, a heave, pitch and roll sensor, a topside control console. In combination with a BlueView 3D Multibeam Scanning Sonar this creates a full survey package.
-
product
SSB Antennas
Shakespeare® SSB antennas enable extra long-range communication, providing a coverage area from hundreds of miles and transmitting between 100-150 watts.
-
product
Biconical Antenna
ZSZ7-0.4-18G-1185
Biconical Antenna, Frequency 0.4~18GHz, Gain 0dBi, VSWR 2.5:1, Vertical Polarization, N-Female
-
product
FMC I/O Module
FM192
Sundance Multiprocessor Technology Ltd.
The FM192-R board is designed to fan out the FMC-LPC connector I/Os to four DB9 connectors and one SEIC connector. The FM912-R provides wireless connectivity via WiFi + BLE and 4G + GNSS/GPS modules. 3x antenna connectors (2x for the 4G + GNSS/GPS and 1x WiFi + BLE) are provided for connecting 3x external antennas. Furthermore, the FM192-R provides an IMU sensor, CAN BUS, humidity and temperature sensor and Audio I/O.
-
product
Combiners
The Amphenol Procom Combiner systems secure a safe combining of multiple Tx channels and splitting of multiple Rx channels transmitted to and received from a base station antenna. Amphenol Procom’s Combiner selection includes Compact Combiners, Cavity Combiners, Hybrid Combiners, Receiver Multicouplers, Power Splitters and Dividers, Couplers, Low Noise Amplifiers, Power Monitors and various Combiner Components.
