Filter Results By:
Products
Applications
Manufacturers
Long-Wave IR
range of wavelengths 8000 nm to approximately 15 µm.
See Also: Wave, Lightwave, Shear Wave, Sub-mm Wave, Microwave, Wavelet, Continuous Wave, Submillimeter Wave, Sine Wave, Millimeter Wave, Shock wave
- Optomistic Products
product
IR LightSource
Universal LightSources emit Infrared (IR) radiant energy and are designed for the testing of IR(infrared) sensors used in remotely-controlled products.The Universal LightSources use a standard 5-volt DC power supply connected via a connecting cable with mating coaxial power plug and terminated with clearly polarized push-on connectors to access fixture 5-volt D.C. supply wire-wrap pins wherever available. Alternatively, the Universal LightSource can be connected to a serial-digital pulse-code-modulated signal source.
-
product
IR Thermometers
This device truly stands out because of its fast response, high/low alarms and dual laser pointer. It is used by maintenance professionals to quickly locate worn machinery, hot spots in electrical panels and defective HVAC equipment.
-
product
IR Thermometers
Is a sensor that consists of a lens to focus the infrared (IR) energy on to a detector, which converts the energy to an electrical signal that can be displayed in units of temperature after being compensated for ambient temperature variation.
-
product
Tunable, Pulsed IR SW & LW OPO IR Source
Firefly-IR
Firefly IR is available in short-wave and long-wave models, providing broad wavelength coverage from 1.4-8.5 µm. The compact and sealed design requires no manual alignment, and can be used in a variety of applications in the lab and in the field. Wavelength selection and scanning is automated and performed via web browser or using a TCP/IP command set. Pulsed operation and high repetition rate provide high peak power and rapid data acquisition.
-
product
IR Sensor
The sensor measures a very useful 0.17 mm in thickness and is made of plastic. Essentially it is a piece of robust plastic that can be used “bare” – without protective housing, such as a metal casing commonly used by other producers. The sensor it is less than 0.2 mm. thin and it is made using plastic membrane. This configuration makes the sensor so robust it can be used “bare” – without protective housing such as a metal container. Due to the fact thatSince the sensor chip can be used applied bare, means it can be used in a totally new ways, which can re-defines todays the current view on application design and reduces the cost of the entire system, and not just the sensor-element as such.
-
product
In-Line IR Sensor
ILA
10:1 Distance to Target Ratio, 32 to 932F. Dwyer Series ILA Non-Contact Sensors, measure temperatures from 32 to 932F (0 to 500C) and provide a linear 4 to 20 mA, 0 to 5 VDC or thermocouple output. The 2-wire signal is compatible with almost any indicator, controller, recorder, data logger, etc., without the need for special interfacing or signal conditioning.
-
product
SparkFun IR Array Breakout
110 Degree FOV, MLX90640 (Qwiic)
It's time to say hip hip array for this IR Breakout! The MLX90640 SparkFun IR Array Breakout is equipped with a 32x24 array of thermopile sensors creating, in essence, a low resolution thermal imaging camera. With this breakout you can detect surface temperatures from many feet away with an accuracy of ±1.5°C (best case). To make it even easier to get your low-resolution infrared image, all communication is enacted exclusively via I2C, utilizing our handy Qwiic system. However, we still have broken out 0.1"-spaced pins in case you prefer to use a breadboard.
-
product
IR Inspection System
EVG®20
The EVG 20 offers a fast inspection method, especially for fusion bonded wafers. A live imageof the entire wafer via IR transmission supports void detection down to a radius of 0.5 mm. The infrared inspection system is a perfect match for fusion bonding processes either as the stand-alone EVG 20 tool or as a station in EVG''s integrated bonding systems.
-
product
Infrared (IR) Laser-Based Phoenix
PHOENIX/IR
Phoenix is a long-range infrared (IR) stimulator capable of testing aircraft electro-optical sensor suites up to 5 km. Phoenix can operate as an independent IR stimulator and/or can be integrated with our other electro-optical and radio frequency range systems (see GTESS and PRTS™).
-
product
Imaging Colorimeters & IR Testing Cameras
Instrument Systems Optische Messtechnik GmbH
The fast, spatially resolved acquisition of photometric, colorimetric and radiometric values with the aid of imaging systems has gained enormously in importance.
-
product
Temperature Measurement IR Sensors & Detectors
ST60 LCC
A single-channel silicon-based thermopile in a LCC package for surface mount assembly in a small active area of 0.61mm x 0.61mm. Time constant of 18ms with Nitrogen encapsulation gas. Delivers a very low Temperature Coefficient of Responsivity of -0.04%/C. This detector has a very short thermal shock response to ambient temperature chang
-
product
C/I Non-Contact IR
Infrared Thermometer
*Safe, non-contact temperature measurement.*Laser spot indicator shows approximate center of target measurement area*Display temperatures in either Fahrenheit or Celsius.*Adjustable emissivity for optimum temperature reading accuracy on a wide range of materials and surfaces.*Min, Max, Difference and Average temperature functions.*Backlight display for easy readings in any environment.*Auto power off for longer battery life
-
product
IR Infrared Thermometers
Includes the GM300 and GM700, a great Value Hand Held Instrument in hard case with battery included. Also includes the RayTemp 2 and IR Micro Thermometer.
-
product
IR Thermal Camera
AMG8833
This is the Thermal Camera FeatherWing: thanks to the Panasonic AMG8833 8x8 GridEYE sensor, it adds heat-vision to any Feather main board. Using our Feather Stacking Headers or Feather Female Headers you can connect a FeatherWing on top of your Feather board and let the board take flight!This part will measure temperatures ranging from 0°C to 80°C (32°F to 176°F) with an accuracy of +- 2.5°C (4.5°F). can detect a human from a distance of up to 7 meters (23) feet.
-
product
SparkFun IR Thermometer Evaluation Board
MLX90614
This is an evaluation board for the MLX90614 IR Thermometer. The sensor is connected to an ATmega328 running at 3.3V with a STK500 (Arduino) 8MHz bootloader. Code can be loaded through the FTDI basic interface and the Arduino environment.
-
product
IR Carbon and Sulphur Analyzer
LD-LCSA-A10
IR Carbon and Sulphur Analyzer LD-LCSA-A10 is a unit for determination of sulphur and carbon equipped with two treatment units including a high frequency induction burner and flexible temperature settings with automatic control. With an analysis time of 20 to 100 seconds and a sensitivity of 0.1 ppm the multi-shielded isolation circuit prevents the machine for high frequency interference. High speed 24-bit sampling improves sensitivity and accuracy.
-
product
IR Temperature Sensors for Critical Equipment Monitoring
FLIR A310
The FLIR A310 is a fixed-mounted thermal imaging camera that can be installed almost anywhere to monitor your critical equipment and other valuable assets. The camera can safeguard your plant and measure temperature differences to assess the criticality of a given situation. This allows you to see problems before they become costly failures, preventing downtime and enhancing worker safety.
-
product
Pocket IR Dosimeter
Shenzhen Chuangxin Instruments Co., Ltd.
This Pocket IR Dosimeter is a handheld radiometer with the characters of high-precision, pocket, stable property and easy to use
-
product
Non-Contact Forehead IR Thermometer
Extech IR200
The IR200 is ideal for quickly screening individuals for elevated skin temperature. This infrared thermometer has a non-contact design that eliminates the need for replacement probe covers and other supplies. The IR200 is accurate to 0.3°C (0.5°F) with 0.1°C/°F resolution when measuring skin temperatures between 32.0°C to 42.5°C (89.6°F to 108.5°F). Adjustable alarm alerts user visually and audibly when temperature exceeds programmed limit. Optimum measurement distance of 5 to 15 cm (1.9 to 5.9 in). Move the Body/Surface function switch to the Surface position for non-contact surface temperature measurements from 0°C to 60°C (32°F to 140°F). With a fast response of just 0.5 seconds, users can simply press the trigger and read temperature on the large backlit LCD display. Memory stores up to 32 readings for easy recall. Comes complete with 2 AA (1.5V) batteries and pouch.
-
product
IR Thermometer w/ Twin Lasers
EST-67
*Twin Laser Pointers for Precise Accuracy & Aiming *Lasers converge at optimal measuring distance *Temp Range: -58 to 1022F / -50 to 550C *12 to 1 Distance to Spot Ratio *Continuous Max Hold Feature *Continuous Backlit Display - Easy to See Readings *Fast response time (150 Ms) for quicker work *High Accuracy Rating of +1% *Carrying Case Included *One year warranty
-
product
High Speed IR Camera
LUXELL CAMERA-S
The LUXELL CAMERA-S is the industrial version with IP67-rated housing of the linear scanning array LUXELL-CORE-S with FPA 256 pixels.
-
product
Laser 4P (Fiber & IR)
This easy to use and time-saving device has a highly accurate axis and renders sharp laser focus during cutting. What’s more? It is efficient, optimized, user-friendly and comes with an in-built chiller.
-
product
Temperature Measurement IR Sensors & Detectors
ST60 TO-5
A single-channel silicon-based thermopile provides lowest cost solutions in a small active area of 0.61mm x 0.61mm in a TO-5 package. Time constant of 18ms with Nitrogen encapsulation gas. Delivers a very low Temperature Coefficient of Responsivity of -0.04%/C. This detector has a very short thermal shock response to ambient temperature change.
-
product
Longwave Infrared Thermal Camera
FLIR A6780 SLS
The FLIR A6780 SLS LWIR camera system makes it easy to measure temperatures of rapid thermal events and high-speed targets, making it an ideal choice for industrial, military, and manufacturing R&D applications. Thanks to its cooled, longwave Strained Layer Superlattice (SLS) detector, the A6780 provides faster snapshot speeds than other detectors for crisp images without motion blurring. Manual and remote-focus lens options provide flexibility to maximize the number of measurement pixels on the object of interest. Simple, single cable connectivity using Gigabit Ethernet provides complete camera control, plus data capturing in FLIR Research Studio software – so users can analyze and understand data faster than ever before.
-
product
Non-Contact (IR) Thermometers
Test Products International, Inc.
Thoroughly testing and diagnosing high efficiency HVACR systems or large surface areas can be labor intensive and expensive. Using the appropriate non-contact thermometer can reduce man hours and help ensure system performance more easily, accurately and affordably.
-
-
product
Programmable Multi-Way Variable-Frequency AC/DC/IR Hipot Tester
AllWin Instrument Science and Technology Co., Ltd.
20 memory,8 test procedureOver-zero start,Over-zero cut offfrequency range from 40.0 to 400.0Hz
-
product
Thermometers (IR / Type-k)
PeakTech Prüf- und Messtechnik GmbH
An instrument for measuring temperature.
-
product
(Visible and IR) Affordable Picosecond Streak Cameras
AXIS-SV
* 3 ps resolution * Spatial resolution of 50 m at the center of the slit * Time window 300ps to 500ns * no trace curvature
-
product
Pocket IR Radiometer
IR-940
Shenzhen Chuangxin Instruments Co., Ltd.
Pocket IR Radiometer is a handheld radiometer with the characters of high-precision, pocket, stable property and easy operation.
-
product
Temperature Measurement IR Sensors & Detectors
S25 TO-5
A single-channel silicon-based thermopile that offers the smallest single element active area size at 0.25mm x 0.25mm in a TO-5 package. Delivers a fast 18ms time constant in Argon encapsulation gas and even faster with Neon gas at 9ms. Delivers a very low Temperature Coefficient of Responsivity of -0.04%/C.
